Home > DCC, Sound & Power >

ESU 51802 SwitchPilot Servo V1.0 Decoder (DCC/MM, RailCom)
ESU 51802 SwitchPilot Servo V1.0 Decoder (DCC/MM, RailCom)
Retail Price: $35.99
Our Price: $28.79
You save $7.20!

Quantity in Stock:(Out of Stock)
Product Code: ESU-51802

The SwitchPilot Servo is able to control up to 4 RC-servos. With its help you are enabled to depict many different motion sequences.
The SwitchPilot Servo is being powered either directly by the digital central station itself or separately by a DC- or AC source (transformer). RC servos or ESU servo motors can be directly connected to its four servo outputs. The 5V voltage needed as well as the special control impulse is generated by the SwitchPilot Servo itself. For each servo, not only lever speed can be adjusted individually but also its end positions. Thus it is possible to operate especially prototypically slow and powerful turnout motors, independent of track- and gauge systems. You could also employ the SwitchPilot Servo for driving signal arms or railway crossings. Also the automatic opening of engine shed doors does not need to remain a dream.

Average Rating: 5 of 5 Total Reviews: 2 Write a review

  0 of 0 people found the following review helpful:
Switch Pilot Servo April 25, 2014
Reviewer: Josť Henriques Iscold Oliveira from Belo Horizonte, Minas Gerais Brazil  
Cool! Excellent Manual

Was this review helpful to you?

  1 of 1 people found the following review helpful:
Big bang for the buck October 13, 2012
Reviewer: Richard-TX from Dallas, TX  
I have tried the Digitrax decoder and the ESU and the ESU gives a lot of bang for the buck.  If you need the signaling outputs that the Digitrax provides, then that is the decoder to buy provided the switch machines are NOT servo motors..  If you need the small size of a servo motor, then  the ESU is about as good as it gets.

Was this review helpful to you?