Home > DCC, Sound & Power > Decoders > N Scale Sound Decoders >

  MRC N 1811 Sound Decoder with GE U23B Prime Mover Sound(Dual Mode DC/DCC)
MRC N 1811 Sound Decoder with GE U23B Prime Mover Sound(Dual Mode DC/DCC)
 
 


Retail Price: $99.98
Our Price: $59.99
You save $39.99!

Quantity in Stock :(Out of Stock)
Product Code: MRC-1811
Qty:

Description
 
Drop-in decoder for Atlas N scale U23B.

Taking miniaturization and MRC's industry leading technology to the limit, this DCC/DC sound decoder is 100% drop-in! The most simple, straight-forward, N-Scale installation imaginable.

Remove the loco body, lift out the factory circuit board and replace with the MRC sound decoder/speaker combo, put the body back on. No wiring needed.
Features
Features:
Two Synchronized diesel prime mover sounds with randomly associated locomotive sounds
User selectable 34 different horns and 8 bells
28 accessory functions allowing more sound control than ever
Programmable individual sound volumes
0.75 amp capacity
Programmable for either 2-digit (1-127) or 4-digit (1-9999) addresses
Programmable start and top voltage
Programmable acceleration and deceleration rate
Programmable 14, 28, 128 speed steps
Selectable factory default speed curve
Directional lighting (F0)
Supports full read back of CV's
Supports advanced consisting (CV19)
Supports programming on the main (OPS mode)
Compatible with NMRA DCC standards
Complies with Part 15 of FCC
10mm speaker included
Directly replaces most Atlas N scale locos PC boards


Average Customer Review: 3 of 5 | Total Reviews: 5 Write a review.

  0 of 0 people found the following review helpful:
 
Good sound. Easy installation. December 7, 2011
Reviewer: David Baker from Cincinnati, OH United States  
I have three of these and an very happy with them. The sound is good, and it is very audible when compared to some of MRC's other products. Installation was no more difficult than any other "drop-in" decoder.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
decoder problem resolved November 28, 2011
Reviewer: Anonymous Person  
Had problems getting it working. Great support for MRC. We were able to correct problems. Programing and mechanical.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
Possible sound issue with this unit December 14, 2010
Reviewer: Robert Blackburn from Hudson, MA United States  
Had to mill the frame a little to allow the speaker to fit. Motor control works fine, but the sound is unstabile at times, occassionally the sound pitch varies. Could be just this particular unit. Otherwise I like the decoder.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
MRC sound decoder critique October 30, 2010
Reviewer: David Rarig from Mayville, NY United States  
Mine wouldn't work when first installed. I had to send it to MRC to get it re-calibrated (repaired).  It lasted only a little while until one of my other locos shorted on a turnout, then it went bonkers again. This time i did not get it fixed. Oh, yes ... I had to mill the frame also.

Was this review helpful to you?

  2 of 2 people found the following review helpful:
 
Mine was not a true drop in ! February 3, 2010
Reviewer: Eric from Chambersburg , PA United States  
I had to mill the frame out some !
But it sounds good !!!!!!
I would buy more!

Was this review helpful to you?

(Your shopping cart is empty)