Home > Tools > Clamps & Vices >

NWSL 48-4 "The Bender"
NWSL 48-4 "The Bender"
Retail Price: $39.95
Our Price: $29.99
You save $9.96!

Quantity in Stock:(Out of Stock)
Product Code: NWSL-48-4

A press bending brake to bend brass, styrene or similar light sheet materials used in model building up to 90 degrees (depending on how far you tighten the press screws).

Work table : 4inw x 1.5in deep x 1-14in high, wt: 12.1oz.
Miniature Press Brake: Up to 3in bend length (exact usable length depends on material hardness and your strength) of up to .020in half hard brass. Adjustable depth guide permits easy, quick duplication of bend placement. Includes reversible steel die, optional urethane die material (permits bends without marring material surface) and operating suggestions.

Average Rating: 5 of 5 Total Reviews: 1 Write a review

  0 of 0 people found the following review helpful:
Good Gadget April 9, 2013
Reviewer: kenne from Australia  
Works well more  a scriber and you bend on the scribe but I see lots of uses for it

Was this review helpful to you?