Digitrax N SDN136PS Series 6 8-Bit Standard 1-Amp Sound and Control Decoder with Speaker

$56.00 $44.79
(You save $11.21 )
(4 reviews) Write a Review
Usually Ships in 2 to 3 Business Days
Digitrax N SDN136PS Series 6 8-Bit Standard 1-Amp Sound and Control Decoder with Speaker
Share with a friend:
Current Stock Level: 14


Works for N and HO models. Wired 8-bit customizable SoundFX decoder, 3 simultaneous voices, selectable generic diesel and steam sounds, downloadable sound, 4 megabit onboard sound memory, 8 Ohm 10 x 18mm oval speaker, 100uF capacitor and 3 FX functions. 1.0 Amp/2.0 Amps peak motor current rating.

Works for N and HO models
Wired 8Bit Customizable SoundFX Decoder
3 Simultaneous Voices
Selectable Generic Diesel & Steam Sounds
Downloadable Sound
4 Megabit onboard sound memory
1" x 0.41" x .19" (25.6 x 10.46 x 4.93 mm)
8 Ohm 10 x 18 mm oval speaker
100uF Capacitor
Accepts PX112-6 Power Xtender
1.0 Amp/2.0 Amps Peak Motor Current Rating
3 FX3 Functions-500mA Total Function Current Rating
FX3 optimized for LEDs or lamps

Read More >

4 Reviews Hide Reviews Show Reviews

  • 4
    Sound for your diesel

    Posted by Bill Whitehead on Aug 10th 2018

    I chose this product mainly because I am putting it in an HO scale RS3 which has limited interior space. You have a choice of basic steam or diesel sounds and, while it does not duplicate the prime mover exactly, it is close enough to the sound I was looking for as this will be a road switcher. I was surprised at the level of sound as I did not want to bore holes in the body shell as this Bachmann did not have the area for a speaker. It is audible and with other sounds it can be heard but at just the right level. Good for what it is made for and I am satisfied with it. Easy to install in cramped HO body shells and good sound level. Easy to program on my Lenz which is usually picky about DCC loco modules sometimes.

  • 4
    Digitrax SDN136PS

    Posted by Jim Kermode on Jun 29th 2018

    Installed in a Bachmann 2-8-0 along with a soundtraxx 1" speaker. Simple installation, cut-off the supplied speaker, solder on the Soundtraxx speaker and plug in the connector. Worked first time on track with an NCE DCC system.

  • 4
    N scale sound decoder

    Posted by Peter on Jun 29th 2018

    Good for fitting into small HO loco - just wish it had a bit more volume.

  • 2
    terrible sound

    Posted by Trevor on May 18th 2018

    The audio on this decoder is so bad, that I had to unplug the speaker. The loco control is quite good, but just terrible sound. And when I tried to mute it, I got a high pitch squeal. Spend more $, get something better.