Peco N PL82 Code 55 and 80 Power Feed Joiners (4 pairs)

These power feed joiners will help address the worries of soldering that many modelers have: they're the safe, clean and tidy way of bringing power to the track. Supplied in packs of four pairs, each joiner has a short length of wire securely pre-soldered to it. The modeler just has to substitute the standard metal joiners for a pair of these where the power feed is required, and pass the wires down through pre-drilled holes on the baseboard. With approximately 8 inches (204mm) of wire on each one there should be plenty of length available to go through most baseboards. In turn these wires can be connected to longer runs of wiring under the baseboard and be taken back to the outlet terminals of the transformer.

These new Power Feed joiners will also save time and help avoid accidental heat damage to the trackwork when using a soldering iron. They are sure to be popular and with three types available to you, it offers a simple solution for that worrying aspect of the hobby. Suitable for N Scale Code 55 and 80, OO-9/HO2.5 Code 80 rail profiles.