Digitrax BDL168 LocoNet Occupancy Detector for 16 Detection Sections and up to 8 Transponder Zones

The BDL168 is a cost effective LocoNet Occupancy Detector for 16 detection sections. Lets you know when detection sections of your layout are occupied. When used in conjunction with one or two RX4 transponder detectors it operates up to 8 transponding zones and operations mode read back. Know what is where on your layout! Lets you know when detection sections of your layout are occupied. When used in conjunction with one or two RX4 transponder detectors it operates up to 8 transponding zones and operations mode read back. Know what is where on your layout!

Occupancy detection for 16 sections
Outputs for LEDs to indicate local detection section occupancy and zone power status on a panel mount display
3 Amp capacity per detection section
Transits Occupancy information over LocoNet
Supports SuperSonic decoder operations
Detects any powered locomotive
Detects any un-powered rolling stock equipped with resistor wheel sets
Plug 'N Play with Digitrax DCC
Configurable with most other DCC systems
Automatically checks layout status when used in conjunction with a computer
Improved Rail Sync Sampling for reliable operation
Transponding with the addition of one or two RX4 allows for 8 transponding sections
Transponding decoders are detected by the RX4s and the information is fed back to LocoNet
Transponding allows you to read back CV values of decoders equipped with transponders
Note: External power supply is needed. PS14 (sold separately) or equivalent is recommended. Multiple BDL16 series detectors can be powered from the same power supply as long as 100mA is provided for each BDL16 series detector.